or Connect
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ask the Boot Guys › Shell Size on older pair of Langes. Where is it marked?
New Posts  All Forums:Forum Nav:

Shell Size on older pair of Langes. Where is it marked?

post #1 of 11
Thread Starter 
Idiotic question, but ive got a well worn 6-7 year old pair of lange comp 120s. I cant seem to find out the label or marking designating the shell size.  I  may be a doofus but im not blind.  I recall it being on the bottom base of the shell but it may have worn away.

Anyone have any idea where the size should be marked on the shell or original liner?  Much obliged. 

 
post #2 of 11
What is the millimeter size on the side of the shell? It should be molded into the plastic on the side of the heel.
post #3 of 11
They were marked on the heel with a sticker that falls off.  Here's a start. My 27.5's have 317 bsl which is marked on the side.
post #4 of 11
 Boot sole length is not on a sticker, it is molded into the plastic.
post #5 of 11
sole length is one thing but if you look inside the overlaps of the lower, the size of the boot will be moulded into the plastic along with the actual model of the mold that was used.  similar happens inside the upper.  there is a lot of info there is you know what it means.

boot sole length can be measured to within a mill or two with a tape.
post #6 of 11
Poorly worded. The size was on a sticker, bsl is molded in.
Quote:
Originally Posted by JDoyal View Post

 Boot sole length is not on a sticker, it is molded into the plastic.
post #7 of 11
I caught that after I re-read your post Steve. My fault for reading and trying to entertain a 3 year old at the sametime.
post #8 of 11
Thread Starter 
Thank you everyone for the quick responses. I should have looked at the right boot, as everyone posted numbers are there.

BSL imprinted on heel is 307 mm 

Upper and lower shell reads.

GT 203 TG 8-9
DX1
Sc.202
TG.8D

So is it safe to assume these are a USD 8D ?  Is that a  25.0/25.5  or  
26.0/26.5 

Edited by kbuzz - 11/1/09 at 1:48pm
post #9 of 11
that would be a 26 / 26.5 mondopoint, and yes, that would be a men's US 8 or 8.5
post #10 of 11
whiteroom - you nailed it! it's an 8/8.5 US  shell.

the DX is for Destrie - right,  it is also on the Zeppa so if you ever have them both out and need to figure which is which and it sometimes gets hard if there was any sanding or planing for balancing DX is right, SX for sestrie is left!
post #11 of 11
Thread Starter 
 once again my sincere thanks to all
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Ask the Boot Guys
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ask the Boot Guys › Shell Size on older pair of Langes. Where is it marked?