edit: title should read SP13
my numbers aren't lining up.
i have boot sole length of 316mm. i set the bindings to 32 hole, lightly screw in the large middle screw to get it a little secure. i then place the toe piece screws in what i think is the proper place: left hole was less than 316 and the right right is greater than 316 (can't remember the exact #'s). when i line up the heel piece, it's not near the proper screw holes for a 316 mm boot (using same logic as the toe piece). it looks right if i keep the toe in the right holes, but i thought i'd check and see if anyone is familiar with this setup. could the rear binding need adjusting to get to the right holes?
i didn't have my boots with me so i didn't spend a lot of time with it. i'll need to figure this out on friday night with boots in hand.