or Connect
New Posts  All Forums:Forum Nav:

MX Pro modifications

post #1 of 3
Thread Starter 
Can you suggest any DIY modifications to the Fischer MX Pro, the original yellow and black model to make them easier to take off? They fit fine but my knuckles are bloody after a week of putting them on and taking them off. Not only are they very tight over the instep but the plastic is knife edge sharp when it's cold. I've put up with it for a few years but I'm sick of it and ready to either change it or chunk'em.
post #2 of 3
buy a heat gun and keep it handy in your boot bag!
post #3 of 3
other than the above

A make sure they warm up a bit before taking them off
B get a fitter to run a flap wheel round the edges of the plastic to dull the sharp edges
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Ask the Boot Guys