Mig, stick, and sub arc, square a carbon core on a stainless plate, then square a stainless plate on that, slap in carbon side plates, clamp, tack, lift with crane into a slab positioner, turn up on side, root weld with mig on a gantry, Do the same for 1 inch wide sub weld, hand weld ends with mig, suck out all the air and send them over to the hot strip mill. Slabs are 3 ft by 20 ft. resulting in about 15000 lb coil. Currently laid off due to lack o orders. See more than a brief diversion.
Originally Posted by Cirquerider
Speaking of SpringsRegular
, where is Sam? Not logged in Since April.
You don't think a new job and baby can keep him from skiing
I doubt it will keep him from skiing, just keep him from wasting time here talking to us.
Cirque, as jimmy axed, yinz comin ta tahn over da holidey? We wants ta ski wit yunz in da woods 'n 'at, if we gits snow that is. We kin goes ta da Nort Cunrry Brewry in Slippy Rock or ta da Penn or even da Church. Hauscum we never met at the White Star in Greensburg?
To all of you Spring folks. Several of us here and on DCSki.com
get together at the Spring and the Knob to ski together. Look for info in a future post in the Get Together and Gathering Forums here on Epic.