New Posts  All Forums:Forum Nav:

Good techs in NYC

post #1 of 6
Thread Starter 
I need my p12's pulled from my dynastars to mount on new 05-06 season boards I scored off ebay. Anybody know of a good shop/tech in NYC (manhattan) that will do it? I called paragon (the obvious big box-ish store) and the tech was willing to do it for $25....that's just to undo 8 screws from a pre-drilled plate.

(The thread-loc I used when I initially mounted them is apparently really good and I almost stripped a head with the pozidriv which is why I want a shop to do it)...
post #2 of 6
Princeton Ski Shop?

What about just taking it to whatever mountain in VT or MA you ski at and find a local ski shop to do it? Shouldn't take them more than 15 minutes to demount/mount.
post #3 of 6
Quote:
What about just taking it to whatever mountain in VT or MA you ski at and find a local ski shop to do it? Shouldn't take them more than 15 minutes to demount/mount.
Second that. That's what I did.
post #4 of 6
Thread Starter 
ah!...didn't think of that one....makes perfect sense...thanks folks!
post #5 of 6
Quote:
Originally Posted by mbp67 View Post
Princeton Ski Shop?

What about just taking it to whatever mountain in VT or MA you ski at and find a local ski shop to do it? Shouldn't take them more than 15 minutes to demount/mount.
Normally good advice, but I would take care of it in advance in this case. It will suck if that thread lock you used make it hard or impossible to remove the screws and the shop needs a day or three to correct it.
post #6 of 6
most thread-locking agents will loosen up with some heat.
If you're game to try again and you haven't mangled the screw(s) too much already, try heating the screw head with a soldering iron tip first.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Ski Gear Discussion