or Connect
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Tuning, Maintenance and Repairs › Marker 1400 EPS Forward Pressure Adjust Location
New Posts  All Forums:Forum Nav:

Marker 1400 EPS Forward Pressure Adjust Location

post #1 of 6
Thread Starter 
Hey guys, looking to get the bindings on my new skis adjusted to my boots. Here's a picture of the back of the bindings on the GS skis. (Crappy phone cam, but it shouldn't matter)

The top screw is the DIN, and the bottom is the length adjustment, so where can I find the forward pressure, and how should it be adjusted?

Paging UP Racer...
post #2 of 6
The length screw "sinks" into the binding when you put your boot in. When set correctly it will be flush with the binding.
post #3 of 6
Your lower screw is the adjustment for correct forward pressure. As steve mentions, should be flush when adjusted correctly with your boot. Engage boot and notice fore/aft movement with your adjustment.
post #4 of 6
...Just checking in since I was paged.. Those guys got it covered.
post #5 of 6
The screw on my 1800s doesn't sink...
post #6 of 6
It definitely should. Is the binding as far forward as it will go? If so, you need to remount the heel piece a little farther forward.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Tuning, Maintenance and Repairs
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Tuning, Maintenance and Repairs › Marker 1400 EPS Forward Pressure Adjust Location