post #1 of 1
Thread Starter 
I have some atomic 412 bindings and I can't set them correctly to my new boots. The new boots are the same brand, and only 1mm different, but for some reason they keep popping off very easily (I can kick them off), even though the DIN is at 8.

What I did was pop my new boot in, and adjust the forward pressure indicator so that it was flush with the back of the tail piece.

Is that all I have to do? If it is, then there must be something else because it doesnt work. I'm thinking it has something to do with the toe piece height, but I dont know how to change that.

If it's that, how do I go about changing it?

Is there a manual online for these binders?