or Connect
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ski Gear Discussion › Need question answered ASAP
New Posts  All Forums:Forum Nav:

Need question answered ASAP

post #1 of 5
Thread Starter 
about to buy some 188 rossignol soul 7's and they come with rossignol axial3 120 bindings. If Mount them for a 335mm boot, can I adjust them to fit a 330mm boot without remounting?
post #2 of 5
Depends on where the heel was when mounted. But normally that binding can adjust 5mm no problem.
post #3 of 5
Thread Starter 

ok, thank you. They are currently mounted for 316mm but I'm fine to remount them once if need be to fit both boots.

post #4 of 5

The adjustment range I could find for this year's model, which is somewhat different from previous years', is 20mm. Which means 10mm up or down IF the binding was mnounted in the center of its range. So you would need to remount for 330 boots; 335's should work fine. I couldn't find specs for the older models so it is possible the adjustment range is higher; however I strongly doubt you could use without remounting unless the original mount was in the forward position.

post #5 of 5
Thread Starter 
Just bought them. I was pleasantly suprised that I could get my 335 boot into the 316 mount point. Forward pressure is either a little high or a little low though. Keeping it at a little low. I'm at -1 because of it but until I've skied it in some good conditions, I won't think about remounting. I think the original owner may have mounted at +1.

Thanks for answering so quickly.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Ski Gear Discussion
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ski Gear Discussion › Need question answered ASAP