or Connect
New Posts  All Forums:Forum Nav:

Binding Set at zero?

post #1 of 5
Thread Starter 

I have 2015 Blizzard Brahmas, with Griffon Bindings. How can I check if the bindings were set at zero.

post #2 of 5
Are you asking about A din of zero ?

Or are you asking about the placement of the binding on the ski ? If so, put the boot in and see where the center line on the boot lines up in relationship to the center line of the ski.
post #3 of 5
Thread Starter 

Yes, I'm trying to determine the placement of the binding on the ski.

post #4 of 5

Look at the ski, either on the top sheet or on the sidewall, for a mark that indicates where the center of the boot should be located.  It might be a line or a circle with a line through it.

 

Look at your boot sole.  Halfway back you'll see a line indicating the center.

 

Put the boot into the binding.  Unless part of the binding covers the mark on the ski, you'll see how the ski mark and the boot mark line up.

post #5 of 5
Thread Starter 


Ok, got it. Thanks. That was easy. I didn't noticed the line at the bottom of the boot.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Tuning, Maintenance and Repairs