or Connect
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ask the Boot Guys › Hotronic wire routing in removable liner
New Posts  All Forums:Forum Nav:

Hotronic wire routing in removable liner

post #1 of 3
Thread Starter 

Running Hotronics in a removable liner. I could run the wire out under the foot bed and out the liner at the back so the wire runs between the liner and the shell.

 

This however puts the wire in a bad location and prone to damage every time the liner goes in/out.

Currently I have the wire exit at the back of the foot bed and up in a space between the ankle bone and the tendon up the back (inside) of the liner (the wire runs between my sock and the liner)

 

Anyone running removable liners with Hotronics and have a better suggestion for routing?

 

Thanks

post #2 of 3

run the pad at an angle so the cable runs between the 1st and 2nd met heads, pointed towards the middle of the arch wall, make your exit cut there just above the edge of the footbed, run the cable behind the inside ankle, out the top. use a reverse velcro patch on the rear of the liner, or trap it between the forward lean shim and the liner if a FL shim is used.

 

no hang up getting in or out and no tape necessary.

 

jim


Edited by starthaus - 2/13/14 at 9:52am
post #3 of 3
Thread Starter 

Thanks Jim..

 

Cheers

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Ask the Boot Guys
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ask the Boot Guys › Hotronic wire routing in removable liner