or Connect
EpicSki › The Barking Bear Forums › Market Place › Gear Swap - Buy & Sell Gear › WTB and PSA for Gear › WTB: bindings fit Marker piston plate
New Posts  All Forums:Forum Nav:

WTB: bindings fit Marker piston plate

post #1 of 5
Thread Starter 
Need to mate with plate pictured below, on a pair of Volkls that's four our five years old. Must accommodate DIN 7.

post #2 of 5

I have a pair of Markers that are on the motion rails of a pair of wrecked volkls. If the rails are the same, these should fit. Here are some pics

 

BTW: I am heading to the Loaf on Tuesday, leaving Boston with an out of the way stop in Boothbay, so if these will work for you let me know if there is somewhere I can drop them for you.

post #3 of 5

QC, the motion binding does not fit the plate, nor does any of the other system bindings.  Any Comp  12, 14 or 16 is what you are looking for  (or even the free ride versions have the same fitting).  IIRC the older 9.1s also fit OK and if you use a couple of shims/spacers you can usually also remove and reuse from the 9.1 SC set up. (but the newer Comps are a better bet)

post #4 of 5
Quote:
Originally Posted by qcanoe View Post

Need to mate with plate pictured below, on a pair of Volkls that's four our five years old. Must accommodate DIN 7.


If you still need the bindings, let me know. I just got a pair of 14 din racing piston bindings that I don't plan on using. Will send pics if you want to see them.

Lowell

post #5 of 5
Thread Starter 
Lowell, thanks. Honestly I hadn't noticed your earlier post. I am all set now with bindings for these skis.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: WTB and PSA for Gear
EpicSki › The Barking Bear Forums › Market Place › Gear Swap - Buy & Sell Gear › WTB and PSA for Gear › WTB: bindings fit Marker piston plate