post #1 of 1
Thread Starter 

My goal heading into this ski season was to replace the liners in my quite packed out Nordica Speedmachine 110's. I wasn't able to find a deal on a set of Intuitions, but managed to find a TGR deal on some new liners out of a Tecnica demon boot- I assume they were takeoffs replaced with an aftermarket liner.

 

The liners are the Ultra Fit Pro version, which Tecnica says is heat moldable. I'd really like to do this to minimize the amount of break in.

 

Does anybody know what Tecnica's recommended process for molding is?