EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ski Gear Discussion › Head Mojo 11 (88 mm) or Head PRD 12 ski Bindings for Head Rev Pro 85 skis?
New Posts  All Forums:Forum Nav:

Head Mojo 11 (88 mm) or Head PRD 12 ski Bindings for Head Rev Pro 85 skis?

post #1 of 9
Thread Starter 

Can anyone tell me which of the two bindings is better for the Head Rev Pro 85 skis (170 cm):  the Head Mojo 11 (88mm) or the Head PRD 12 (88 mm)?  The Mojo 12 has the much wider brake.

 

I'm 184, 5'9".

 

Thank you for yopur help!

post #2 of 9

Either will work

 

Din setting depends on your boot size but you should be within range

 

The Mojo 11 will have a lower stand height / lighter weight

 

The PRD 12 will be adjustable to fit other boots and allow aft/forward adjustment

 

So if you prefer adjustability get the PRD

post #3 of 9

The Mojo 11 has a very different heel design that is much less sophisticated. The PRD 12 is a much better binding.

post #4 of 9

Whitroom 

 

Is it the SX Heel on the Mojo 11

 

And the LD Heel on the PRD 12  ???

post #5 of 9

yes.

post #6 of 9

I own the Rev 85 and would highly recommend the PRD binding which is adjustable fore and aft. My experience is that this ski performs far better on harder snow when your boot is mounted "at the center line" of the ski. Small movement aft resulted in  loss of edge holding power. Fine tuning is a good thing!

post #7 of 9
Thread Starter 

Thanks to you all; very helpful!  This site is the only place where I know I'm getting good advice and direction.

Michael

post #8 of 9
Thread Starter 
Will the PRD 12 binding work for a DIN of 5.5?
post #9 of 9

Yes, the PRD low din is 3.5.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Ski Gear Discussion
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ski Gear Discussion › Head Mojo 11 (88 mm) or Head PRD 12 ski Bindings for Head Rev Pro 85 skis?