EpicSki › The Barking Bear Forums › Market Place › Gear Swap - Buy & Sell Gear › WTB and PSA for Gear › WTB: Race plates (FreeFlex or undrilled)
New Posts  All Forums:Forum Nav:

WTB: Race plates (FreeFlex or undrilled)

post #1 of 8
Thread Starter 

Hi gang -- I'm looking for some new or used race plates to put on a new pair of GS skis I just picked up.  I will be mounting 2006-2007 Tyrolia FF and have a BSL of 327.  Anyone got anything for me?!?  Thanks!!

post #2 of 8
post #3 of 8

Hi Dan. There is a new set of Head/Tyrolia Race Plates listed on E-Bay for $99. The race plates are not pre-drilled.

post #4 of 8
Thread Starter 

Thanks for the tip, JMD.  I've gone through those guys before and they're great.  Definitely a possibility, although I was hoping to keep it under $75 and over 13mm.

 

Jzamp, what's the height on those VIST plates?  You're pretty sure that the prior holes won't overlap a drilling for Tyrolia?

 

Thanks to both of you!
 

post #5 of 8

the plates are 12mm which is about standard for GS skis. keep in mind that stand height (ski/plate/binding) is dictated by FIS...

as far as the overlapping of holes I'm not sure. Theres plenty of room left and your BSL is 10mm longer than mine. I would have to check with the tyrolia pattern tho.

post #6 of 8

Those Vist plates can be drilled to they look like swiss cheese and it won't matter. They are a good plate and a good value. 

post #7 of 8

after looking at tyrolia patterns I think you should be fine... the holes aren't the same but they should fit around the old ones easily.


let me know if you are willing to give it a try... 

post #8 of 8
Thread Starter 

If Phil says pull the trigger, then I better pull the trigger.  PM on its way, jzamp...

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: WTB and PSA for Gear
EpicSki › The Barking Bear Forums › Market Place › Gear Swap - Buy & Sell Gear › WTB and PSA for Gear › WTB: Race plates (FreeFlex or undrilled)