EpicSki › The Barking Bear Forums › Market Place › Gear Swap - Buy & Sell Gear › FS : 11/12 Stockli CX 170cm with Tyrolia RFD14 Bindings $450 plus shipping.
New Posts  All Forums:Forum Nav:

FS : 11/12 Stockli CX 170cm with Tyrolia RFD14 Bindings $450 plus shipping.

post #1 of 7
Thread Starter 

1000

 

1000

 

1000

 

1000

 

1000

 

1000

 

Listing there on Epic before posting on Ebay. For sale a pair of 11/12 Stockli CX 170cm with Tyrolia RFD14 Heavy Duty Bindings (din 4 to 14). 116-69-100 15.1 Radius. Skis are in excellent condition with very little use. Freshly waxed and sharpened, ready to hit the slopes. Very light scratches on top sheet and very light scratches on bases. Bases and edges have 95% of life remaining. Bindings are adjustable to most boot sizes (263mm to 363mm) without needing tools or remounting. Priced at $450. local pick-up in Summit County Colorado. Will ship for an extra $25. USA only. Here is Dawgcatching's review of the Stockli CX in the same length.

Stockli Laser CX: new for 2011, a medium-radius, medium energy fronside power carver. Not overly stiff. 69mm underfoot. Length tested: 170cm

 

This ski was set up with that medium flex plate that Stockli was using, in addition to a demo binding, which brought it quite far off the snow. I took 2 runs on it: first was a bulletproof groomer of manmade snow, and the 2ndwas in some bumps. I surprised that the CX was not all that stiff: softer in flex than other race derived skis I tried (Blizzard SLR IQ and GSR IQ). It packs a wallop, though. This ski is all power and edge hold. Feel is medium energy: you can work the tail for some pop, but it still a fairly damp feel. Edge hold and power are off the charts, and it felt as locked in as any ski I tried, perhaps more. The thing was, I could change the radius of the arc, as it wasn't all that stiff, and wasn't an auto-carver like some of the frontside skis around. Basically, it was as if they took their competition cross ski and softened it 15%. A very unique feel, and it could handle anything I threw at it. It was one of the few skis not to break loose on the really steep pitch, heading down into the village, which by that time of day, was completely scraped clean and hard as a rock. On the CX, I could get aggressive at the top of the turn, gain a bunch of angulation, and leave railroad tracks with confidence. It was a beast, but didn't beat me up. Stability was high, but not quite as high as the SX. What a thrilling carver. In the bumps, it was adequate, but a bit stiff in the tip. Lacking forgiveness, the ski takes any error out on the skier. Workable for a good bump skier, not for a tired bump skier. This is a ski I would own.


Edited by JMD - 1/5/13 at 12:42pm
post #2 of 7
Thread Starter 

Now listed at a higher price on E-bay but will honor this price if purchased through Epic Gear Swap.

post #3 of 7
Thread Starter 

Bump

post #4 of 7

Bump for a great deal. How much use approximately?  

post #5 of 7
Thread Starter 

Hi dawgcatching. This pair of Stockli CXs have been used about a dozen half days. The tops have light scratchs and the bases have only very light scratches. Bases lightly ground only once to flatten the bases and set the bevels to .7 degree base and 3 degree sides. Freshly waxed and sharpened. Really ready to ski. JMD

post #6 of 7
Thread Starter 

Sale pending. Thanks, Mike.

post #7 of 7
Thread Starter 

Stockli CXs are SOLD!!!!!!!! Thanks Mike.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Gear Swap - Buy & Sell Gear
EpicSki › The Barking Bear Forums › Market Place › Gear Swap - Buy & Sell Gear › FS : 11/12 Stockli CX 170cm with Tyrolia RFD14 Bindings $450 plus shipping.