EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ski Gear Discussion › Rossignol I-Box Plate and Binding
New Posts  All Forums:Forum Nav:

Rossignol I-Box Plate and Binding

post #1 of 4
Thread Starter 

Anyone know if a Rossi 120 Pro binding (turn table heel, black and yellow) is compatialbe with the rossi i-box plate?  Binding is a bit older by functions nicely.  Not sure if it will fit the bolt pattern found on the i-box of a couple of years ago

 

Thanks

post #2 of 4
Don't think so. Iirc the pro has a 3 screw toe piece
post #3 of 4
Thread Starter 
Actually, two larger screws in front of afd pad, then two smaller screws in front of wings. Compatible?
It's not the old fashion with middle screw below toe piece

Thanks
post #4 of 4
Sounds like it should work then, assuming it is the older Rossi plate rather than the newer one. The newer one (from about 2009?) takes the px race binding, same toe mount I think but different heel mounting.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Ski Gear Discussion
EpicSki › The Barking Bear Forums › On the Snow (Skiing Forums) › Ski Gear Discussion › Rossignol I-Box Plate and Binding