or Connect
New Posts  All Forums:Forum Nav:

Roto Tip

post #1 of 2
Thread Starter 

I just got a new roto setup from SVST and I came up with a usage tip.  If using a cordless drill, set fastening torque to a low number--I started at 1--with the clutch.  That way, if you press down too hard, the brush will stop versus potentially doing damage to the ski.  

post #2 of 2

You should not press at all.


I mean No pressure whatsoever!


If you are stopping the clutch even on 1 you are pressing.

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Tuning, Maintenance and Repairs