EpicSki  ›  The Barking Bear Forums  ›  Skiing Forums  ›  Ski Gear Discussion  ›  Atomic Race 614 Binding Adjustment Question
Forum Nav More Forums | All New Posts | New Thread

Atomic Race 614 Binding Adjustment Question

#1
Rating: 0
11/5/09 at 7:07pm
  • Joined: October 2008
  • Post Count: 8
I just got a used pair of '04 Atomic GS11 skis with Atomic Race 614 bindings. I adjusted the length so that my boots lock in. But how can I tell if I have the bindings too tight or loose to the boot?

From what I can tell, the boot is in there solid. No play. It also doesn't feel too tight like I'm damaging the binding. Thanks for any help.
Export to Wiki
#2
Rating: 0
11/5/09 at 7:24pm
  • Joined: October 2000
  • Location: Gallatin Gateway, Mt. usa
  • Post Count: 2,652
The screw in the middle of bindings sets the gross boot size in 5mm increments. Then you need to adjust the forward pressure screw which is located on the rear of the heel piece under the release lever. This screw should adjusted (with the boot removed only) so the head of the screw is flush with the rear of the housing when the boot is in the binding. If you need to make more adjustment remove the boot from binding, turn the screw in or out a few clicks, then put the boot back in and check if it is flush again. This make take a couple of try's. Remember, remove the boot before turning the screw in or out. Pretty simple, just be accurate when assessing whether the screw is flush or not. Good luck.
Export to Wiki
Forum Nav More Forums | All New Posts | New Thread