EpicSki  ›  The Barking Bear Forums  ›  Skiing Forums  ›  Tuning and Maintenance  ›  Look PX 12 Binding Forward Pressure Mount
Forum Nav More Forums | All New Posts | New Thread

Look PX 12 Binding Forward Pressure Mount

#1
Rating: 0
9/28/09 at 12:09pm
  • Joined: January 2009
  • Post Count: 21
Some information.  This is only relevant if you don't want to change the heel binding position after mounted.

Since the Look PX12 WB lifter doesn't have an adjustment for forward pressure (but has an indicator).  I mounted them on a piece of plywood to determine the mounting position with the heel binding adjustment in the middle.  It was 5 mm forward to get forward pressure.  This 5mm forward was after the boot sitting in the binding without pressure but tight to the bindings. 

After trying to find this information, this might not be exact but it is what I've found out and it might help someone else.
Export to Wiki
#2
Rating: 0
9/28/09 at 4:22pm
  • Joined: October 2005
  • Location: CA
  • Post Count: 201
Why do you say it does not have FP adjustment? PX12 heel has a tap that you can lift and move the heel back and forth in approximately 4-5mm increments that are enough to adjust the FP....
Export to Wiki
#3
Rating: 0
9/29/09 at 6:02am
  • Joined: January 2009
  • Post Count: 21

Correct which is what I called the heel binding adjustment and that is the only adjustment other than re-drilling. So if it was too far forward, you would have to remount the binding.  

Export to Wiki
Forum Nav More Forums | All New Posts | New Thread