Related Articles
-
Spring Snow Base Preparation
Edited on 4/24/11
- Edge Tuning So Easy Even An Adult Can Do It
Edited on 4/19/11- Waxing Light Hot Scraping
Edited on 4/19/11- Base Repair Options
Related Gear & Resorts
Alphabetical Article List
Waxing Hot Touch Crayoning And Smearing
Hot Touch Crayoning & Smearing Wax
To save time, wax and mess while hot waxing solids, Hot Touching is
better than dripping and then ironing, especially with harder, cold waxes.
Hot Touching & Crayoning uses the
least amount of solid wax, total effort, time and is the least messy. By briefly touching a bar of wax against the base of a hot waxing iron, the wax softens and is easier to apply to the base by crayoning a section of a ski or board at a time. When the crayoning becomes less effective, repeat the hot touch and crayoning until the base has a reasonably even and thin coat of wax. Then make several passes with the iron to liquify and evenly spread the wax over and into the base.(If you are concerned with a hot iron and a very thin layer of wax on your base, using a sheet of teflon between will protect the base and make for smoother ironing.) Let cool & harden, scrape and brush. The scrapings will be minimal compared to drip/hot waxing and scraping.
Hot Touching and Smearing is similar to Crayoning. The difference is after touching the wax bar to the base, you smear the wax onto the base with the iron. This can be somewhere in between the drip
and crayoning methods in both technique and amount of wax applied.Following hot touching and smearing with a light hot scrape or fiberlene between base and iron can be comparable to crayoning requiring minimal scraping and brushing.
Best Regards,
Terry (aka Alpinord)
Ski & Snowboard Base Prep, Waxing, Tuning, Tools, Supplies & Accessories
- Edge Tuning So Easy Even An Adult Can Do It
Comments (0)